Free 1911 disassembly reassembly guide software for linux

lib5600x is a library implementing Motorola DSP5600x disassembler. Its an ANSI C link library that should be useful for people writing debuggers, memory monitors etc for DSP5600x chips.

Usage

1. First you call two initialization functions in the library. This step is mandatory:

make_masks();
make_masks2();

You pass nothing and check for no results -- these functions are guaranteed to succeed.

2. Now you have to allocate memory for a structure that will be used for passing data to/from the library. You may do that on the stack

struct disasm_data dis, *d = &dis;

Yes, the pointer will be useful, too. The disasm_data structure is defined in 5600x_disasm.h file. Lets take a closer look:


#define LINE_SIZE 256

struct disasm_data
{
unsigned char *memory;
char line_buf[LINE_SIZE];
char *line_ptr;
char words;
};

First member -- "memory" -- should point to the opcode you want disassembled. IMPORTANT! The library expects it to be a 24-bit word, so if your assembler creates 32-bit words, youll have to make a simple conversion. Take a look at test.c to see how it is done. Whats more, the library may wish to evaluate two words at a time, so you have to account for that -- this is also demonstrated in the example source.

3. After properly setting up disasm_data struct (i.e. "memory" pointer), you call following function:

int disassemble_opcode(struct disasm_data *);

This function takes pointer to the struct youve just prepared as an argument. When it returns, disasm_data structs "line_buf" member contains the disassembled opcode as a string of ASCII characters. "line_ptr" should be of no interest to you (it is merely a internal variable) and "words" holds the number of 24-bit words you should advance your memory pointer by. This variable is also available as a return value of above function. Again, I
shall refer you to the example source.

4. Repeat step 3 until you run out of code to disassemble.

Testing

First, check out the makefile and make sure it contains proper flags and defines for your architecture. Big endian users should add -DBIGENDIAN to CFLAGS (Id appreciate if someone created Autoconf script to avoid such tricks). Following that, type

make
./test example_dsp_binary

and compare the output (visually) with example.a56 which is a source code I used to create example_dsp_binary and which contains all instructions and addressing modes described in DSP56000/DSP56001 Digital Signal Processor Users Manual. You can also diff your output and supplied example.out file to check if there are any differences (there should be none).

Debian Desktop Users Guide project is a guide which is targeted toward new Debian users.
It brings up-to-date and effective documentation to new Debian users.
This document is based on the Progeny users guide.
This guide is planned to be released in conjunction with Sarge.
Enhancements:
- sections 6.2.1 and 6.2.2 have been rewritten.